Latest Products
-
AXK500147BN1 Board to Board SMT Socket Connector 100 POS 0.5mm
$3.85 Inc Tax -
TPS70933DBVR IC REG LINEAR 3.3V 150MA SOT23-5
$1.19 Inc Tax -
On Semiconductor Zener Diode 1SMB5929BT3G 15V 3W 2 Pins, 150 °C
$0.50 Inc Tax -
Phoenix Contact Fixed Terminal Blocks 2P 5mm
$2.19 Inc Tax
S-Click Minute Mech Timer 2-Wire 240V 1.7A HNS410TM
Our minute timer switch is ideal for domestic use and can be retrofitted to most installed lights. A blue LED indicates device status and gives an expiry warning within the last 10 seconds before the lights time-out. The timer settings are retained even after loss of power and can be configured to power up on or off after loss of mains power.
Programming your chosen off time couldn't be simpler. A sustained 10 second press of the button enters programming mode. Just tap the button once for each minute of run time you require, up to 60 minutes. Programming mode expires 10 seconds after the last tap, and the unit then commits your settings to memory. If you happen to press the button more than 60 times, the maximum run time of 60 minutes will be stored.
Applications and Compatibility
The HNS410TM is perfect for lighting in areas such as hallways, garages, laundries and wardrobes. All require adequate lighting but are generally not occupied for extended periods. Using a minute timer switch in these areas prevents the excess energy consumption caused by leaving lights on accidently.
The HNS410TM is compatible with HPM and Clipsal Style wall plates. Multi-way switching capable using 240V normally open momentary switches-refer to the product datasheet for more information.
Not suitable for fans, motors or iron core ballasts.
Operating Conditions
Operating Voltage: 230 - 240V a.c. 50Hz
Operating Temperature: 0 to +50 degrees Celsius
Compliance Standard: CISPR15, AS/NZS 3100, AS/NZS 60669.2.1
Maximum Load: 400VA
Minimum Load: 10VA
Maximum Current capacity: 1.7A
Terminals: Screw Terminals suit 0.5mm2 to 1.5mm2 stranded (bootlace terminal recommended)
Note: Operation at temperature, voltage or load outside of the specifications may cause permanent damage to the unit.
The HNS410TM is to be installed as part of a fixed wire electrical installation. By law, such installations must be made by an electrical contractor or similarly qualified person. For operating instructions and important safety warnings, refer to the product User Manual.